|
|
樓主 |
發表於 2012-12-19 14:27:01
|
顯示全部樓層
本帖最後由 obee 於 2012-12-19 14:28 編輯
kuromitms 發表於 2012-12-19 12:18 
obee hing 整咗幾多錢?有無圖?材料詳情係邊到買,可否PM我,我都好想整 ...
1. Topology:
Transformer 220V AC in -> Step down to: 15V, 13V, 9V and 9V (4 secondary outputs)
-> (optional on/off switch) -> diodes -> capacitor (4700uF or above is ok) -> Teddy's SuperReg -> output
2. About the capacitor:
According to Teddy, using 4700uF for that capacitor is enough, minimum should be 2000uF
3. About the Regulator:
Each regulator is a separate Teddy Pardo's SuperReg:
http://www.teddypardo.com/DIY/SuperTeddyReg.html
You can buy bare PCB from him ($8 each), it takes 1-2 weeks to ship to HK. You need to buy resistors and capacitors yourself and solder the resistors & capacitors by yourself.
You may also buy finished regulator from him ($59 each). This is highly recommend if you don't want to "折騰一番". Just tell him the output DC voltages you need for each broad after placing order, and ask him to suggest the DC input voltage.
4. DC Cable
DC cable, similar to power cord, does affect sound. So you should choose one that can produce good sound.
5. Other points to note
Each regulator supports 1A maximum, if you want higher current output, please use other regulator design (or ask Teddy to make one for you). My another DIY PSU using AMB Sigma 11 can support higher current (I tried that it can support 8A).
http://www.hiendy.com/hififorum/ ... &extra=page%3D1 |
|