調校唱頭角度的簡單方法

kahw

I found a perfect way to adjust and guarantee it is accurate!!!!!!

Adjust plus!!
http://www.adjustplus.de/?lang=en

No need to guess anymore!
Using computer!

kahw

I use this to adjust speed and if you are pro enough to read all the data, which I am not, it can tell whether your arm and cartridge are matching well or not by reading the chart. I am still in the process to understand it.

nagramen

Thanks to kahw c-hing for the introduction. How much does this software and vinyl LP package cost?

nagramen

Setting azimuth would be easy if it can be done at the tonearm. But many arms do not support this and azimuth is adjusted by tigthening/loosening the cartridge screws.

kahw

nagramen 發表於 2014-4-22 08:22
Thanks to kahw c-hing for the introduction. How much does this software and vinyl LP package cost?

...

It is about 2k+

kahw

nagramen 發表於 2014-4-22 08:25
Setting azimuth would be easy if it can be done at the tonearm. But many arms do not support this an ...

Mmmmmm.....
It should work too. Just need more time to set each angle for reading.

澳門客

很多唱臂左右平衡是不能調校的，因為設計當正確安裝好唱臂時，左右平衡定必一致
看左右平衡一般是把鏡子放在唱盤上，把唱頭放上，就可觀察唱頭左右是否平衡

澳門客

　樓主這個應該是調校超距時，安裝唱頭二支螺絲不平衡對中所致，所以部分唱臂，調超距時不是調二支安裝唱頭螺絲前後，相反地，二支安裝唱頭螺絲是固定的，調校超距是把整體唱臂順着安裝中線前後移動，例如SME，但這種唱臂在全新定位安裝時找位置會較復雜

nagramen

kahw 發表於 2014-4-23 02:05
It is about 2k+

Thank you!