Oppo UDP 203 Latest Public Beta Test Version UDP20X-38-0215B

chhanthony

Oppo UDP 203 Latest Public Beta Test Version UDP20X-38-0215B

Release Notes:


This release is for the OPPO UDP-203 4K UHD Blu-ray Disc Player.

Special Notice:

Once this Public Beta firmware is installed on the player, you can revert back to the previous Official release via a USB thumb drive. There will be no issues upgrading to any future official or beta firmware release.


Comparing to the current Official release version UDP20X-33-1229, the major changes included in this version are:

Added the "Target Luminance" setting under HDR Settings to allow tweaking of the HDR to SDR conversion.
Added the RS-232 command "QHS" for querying the HDR playback status.
Added support for the HEVC 6.0 and 6.1 profile levels.
Improved the experimental "Strip Metadata" feature.
Improved stability when playing music from DLNA servers.
Improved compatibility with exFAT formatted hard drives over 2TB in capacity.
Resolved a stuttering playback issue with 3D titles.
Resolved an audio dropout issue with UHD title "Deepwater Horizon".
Resolved a playback issue with UHD title “Star Trek Into Darkness”.
Revised the VFD text during a firmware upgrade that allows customers to upgrade the firmware without connecting a display.
General disc compatibility improvements based on recent and upcoming UHD Blu-ray releases as well as user-submitted disc samples.
All features and improvements of the previous firmware are also included in this version.



http://www.oppodigital.com/blu-r ... mware-38-0215B.aspx

ac388

Thanks Anthony.
Be aware of the following problem before this upgrade ...

Originally Posted by Bob Pariseau View Post
Questions for Folks Experiencing Player Crash on Tray Open with the *NEW* 0215B Firmware

Please only respond to this if you have experienced this *SINCE* updating to the new Public Beta 0215B firmware:

The symptom here is that the opened Tray won't close when commanded, AND if you power off the player (using Power button on Front Panel or on Remote), it takes about 15 seconds and LEAVES the Tray open, but the Tray closes without problems on the next power up. (That last part is how you know the player has Crashed, because the power off is being done by the Power Off Failsafe process timer.)

NOTE: If the Tray won't close even on the subsequent power up, then you have a different problem -- likely a mechanical blockage of the Tray or a failure of the Tray position sensor -- and should call OPPO Tech Support for warranty service.

If you have experienced such a Crash with the NEW 0215B firmware -- and again, please limit your response to cases that have happened SINCE updating to that firmware:

1) Did you open the Tray while a disc was playing, or did you open the Tray from Home Menu after Stopping the most recent disc and waiting for Home Menu to appear on screen? If the former, what type of disc (e.g., CD or UHD Blu-ray).

2) Do you have the player's Standby mode set to Energy Efficient or to Network Standby (Setup > Device Settup)

3) Do you have IP Control enabled (Setup > Network Settup), and if so, are you using Ethernet or Wifi for your networking to the player?