SD transport 384

hkborn

sd transport

★ Compatible Recording Media: SD Card, SDHC Card

★ Supported file systems: FAT16, FAT32

★ Supported file formats:　
　(1) RIFF WAV file
　　　sample rate: 44.1KHz, 48KHz, 88.2kHz, 96kHz, 176.4kHz, 192KHz, 352.8KHz, 384 kHz
　　　-word size: 8 bit, 16 bit, 24 bit, 32 bit
　( 2) DSDIFF file
　　　sample rate: 2.8MHz (DSD64), 5.6MHz (DSD128), 11.3MHz (DSD256)
　　　Number of channels: 2 (stereo)

★ output signal format: I2S (C-MOS, output LVDS), DSD (C-MOS, output LVDS), S / PDIF (coaxial) (Note)

★ Master Clock
　　　device use: ultra-low-jitter oscillator module type made ​​by NDK
　　　clock frequency: 98.3040MHz, (auto switching) 90.3168MHz
　　　Oscillator module is built into the side-DAC

★ Electrical isolation between the DAC and SDTrans384

★ I2C interface available for external control LSI

★ firmware can be updated from object files stored on SD card

★ remote terminal I / O can be monitored from outside of state control and operation

WAV file and the case of DSD files (Note) 352.8KHz, of 384KHz, the output S / PDIF is not possible. Will be output only, DSD I2S.

skto

hkborn Ching,
How Much?
Come with Case and power supply?
thanks,
skto

hkborn

it's still a development project, quite expensive because of quality of parts, almost HKD5000 for this board

ALANVCD

HKBORN HING,

You're using it too? I've order 1 when it first come out last year, sounds amazing.

Too bad that cannot got the sync option board....yet....

hkborn

sync option is extremely expensive so I didn't get it, u may ask Bunpei to send u one, i have yet to find out i2s input for my dac

ALANVCD

Yeah....will check with Bunpei. I'm now using a self build DIY Dual Mono Buffalo II(ESS9018), with Adam S3X-V, so far so good.

hkborn

received and play with it for a while now.
I would highly recommend it to anyone without reservation!!!
so far, i just use it to play 16/44.1 files and it gives out the cleanest background, huge dynamic range and it's now my best cas source player.

CKKeung

hkborn hing,

May I know how you connect the digital outputs of this SD Transport to your DACs?

Are you using its S/PDIF (coaxial) output only or also its I2S (C-MOS, output LVDS) and DSD (C-MOS, output LVDS) outputs?

Thanks!

hkborn

CKKeung 發表於 2012-5-14 08:31
hkborn hing,

May I know how you connect the digital outputs of this SD Transport to your DACs?

I just use BNC output for now, I don't have dac with 9018 chip and other dac with i2s. So there could be significant improvement later on.