又要幫手搞部anthem喇

薄餅薯片

先試咗5隻喇叭加埋隻十仔識出聲喇，今次又輪到ARC有問題左右前同右後置都無問題，輪到左後無聲出，電腦再話（Erro measurement was not able to acquire a proper . ( code 0x03) 又唔得，重新裝過又唔得，試咗幾十次都係咁，真係火都黎請問有無師兄幫到手？

別蕉早

哦....咁樣！
其實係部電腦出現左問題，
之前有好多師兄都有來電問過我依個問題，
有時前後五隻喇叭同個超低都做到，
但做第二個又做唔到！（點解呢？）
其實係唔關部300事，
因為係部電腦既USB同pc作怪，
但不要緊！有我係到唔洗怕！
你pm我留電話同你talk丫，
在此和你説聲對不起先。

薄餅薯片

別蕉早 發表於 2012-5-9 22:45
哦....咁樣！
其實係部電腦出現左問題，
之前有好多師兄都有來電問過我依個問題，

已pm

rklpoon

幫你爬緊文-Avs forum,暫時可試/check：-

你玩5.1定7.1？如7.1要揀bacK=surround bacK,ceiling=presence
行ARCmanual mode/open existing file/QuicK measure試下揀後面唔出声既喇叭睇下奌

rklpoon

薄餅薯片 發表於 2012-5-9 22:56
已pm

可能係usb port/irq撞左,個usb adopter software有d野可以set？如data flow rate可埬11,520最大数值之類。

gundamfix2005

我之前都有同樣問題, 如ching係玩 5.1 要在manual mode度unclick返rear果個格仔

rklpoon

如玩5.1要揀無rear/height 喇叭(在ARC config下？)

rklpoon

gundamfix2005 發表於 2012-5-9 23:15
我之前都有同樣問題, 如ching係玩 5.1 要在manual mode度unclick返rear果個格仔

x100

rklpoon

see the below pls(from AVS forum):-

[post 9142]
Author : Tigger!
Date : 02-17-12 02:09 PM

just bought MRX300
followed install/ setup to the letter (what few there are)
during ARC Im having problems (surprise)

so far spent 7 hours over 2 days with various little problems/ updates/ downloads ect. ect. its now 1:30am i'm middle of my work week so pardon my mood::confused:

tried running ARC many many times these are the results.
speakers in testing order and what channel is displayed:
LF-OK (loud)
center-OK (not to loud)
RF-OK (loud)
R surr-ok (loud)
Movie Right rear AUX error measurement was not able to acquire proper  response code 0x03

*note* I have the 2 extra rear channels set to zone 2 / off

this is where the program stops
now when go in under advance menu and test individual channels choice rear surround left and right work but the  left and right AUX rear do not work and halt the testing..
also the SUB is silent for testing as well
Whats going on here???

during normal operation (out of correction/ test modes)
I can hear ALL channels functioning fine...
i dont know what else to do..
i have tried most everything I could search for in these threads (learned ALLOT) but not to fix this problem (this is more than an "issue")

Self powered Sub is hooked via LFE, no EQ, (HSU brand)
please help im soo tired and will have to continue to 3rd day :eek:
thank you!!:o

So Sorry for the frustrations!  I'm hoping this is a simple classic mistake that most all of us with 5.1 made the first time we setup the MRX...

You have correctly set the Rears/Heights to Zone 2, that is good... now when you run ARC, it will ask which speakers to test... you need to set the Rears/Heights to "No Speaker".  ARC actually walks around your speakers in a clockwise pattern starting with the:

1) Front Left
2) than Center
3) Front Right
4) Right Surround
5) Rear Right Surround
6) Rear Left Surround
7) Left Surround
8) Sub

It sounds like you are getting to #5 (which you should not be testing... and won't be once you set ARC to "No Speaker").  For most all of us, this was the reason our first ARC runs failed.  Once the Rears/Heights are set in ARC to "No Speaker" before you begin your sweeps, steps 5 & 6 will be skipped.

薄餅薯片

先多謝咁多位幫手，我玩5•1，都有做咗大家題出嘅步驟，但都係唔得，我估應該部電腦撞咗，不過而家有joe兄肯出埋手，黎緊應該無問題。多謝大家

iwantbd

禾深信----有Hiendy-----大家刀Friendy

pam_jack

gundamfix2005 發表於 2012-5-9 23:15
我之前都有同樣問題, 如ching係玩 5.1 要在manual mode度unclick返rear果個格仔

唔見你一排...你個簽名多咗貢多野...係時候要出個會員分享喇...

gundamfix2005

薄餅薯片 發表於 2012-5-9 23:44
先多謝咁多位幫手，我玩5•1，都有做咗大家題出嘅步驟，但都係唔得，我估應該部電腦撞咗，不過而家有joe兄 ...

要將部電腦鏟底，重新裝返就冇問題啦 (包括我在內)

gundamfix2005

pam_jack 發表於 2012-5-10 05:19
唔見你一排...你個簽名多咗貢多野...係時候要出個會員分享喇...  ...

邊有D咁嘅樹 ，換咗Ｄcheap野姐，同kachow比真係 ，而家煲緊SOMMER線，下個月上來聽吓，準備換DAC (new target : mytek / wyred DAC2)

rklpoon

gundamfix2005 發表於 2012-5-10 09:13
邊有D咁嘅樹 ，換咗Ｄcheap野姐，同kachow比真係 ，而家煲緊SOMMER線，下個月上來聽吓 ...

sommer pc 定rca? ? model 用係邊度?效果如可? 3q.

gundamfix2005

rklpoon 發表於 2012-5-10 09:51
sommer pc 定rca? ? model 用係邊度?效果如可? 3q.

sommer 4.0 ---> MRX 300
A5 ---- > Oyaide GPX
All RCA are used sommer carbokab   

hithere

大家好, 想請問吓大家, MRX 300 有無 4k passthrough ga, 睇spec 好似無提過
雖然宜家無其他野 support, 但部機可能會玩好幾年, 到時無得玩 4k 會好愁

randyma

hithere 發表於 2012-5-10 16:25
大家好, 想請問吓大家, MRX 300 有無 4k passthrough ga, 睇spec 好似無提過
雖然宜家無其他野 support, 但 ...

No 4k passthrough ga.

hithere

oh, 咁要諗諗上唔上 MRX300.. 哈哈

Lunchbox360

Bluray 直上投投，唔洗經部300重好喇