Anti-Mode 8033S-II 低頻修正器 !

claero

hikaru 發表於 2013-5-15 18:30
所以之前同壞人討論過, 最大問題器材既EQ, 我相信yamaha EQ先俾到咁大range....... ...

百事佬話我知係無乜用，因加幾db,度出來可能得好少

claero

ryanenen 發表於 2013-5-16 11:25
我有問Kelvin show 條 target curve, 先知8033 做到幾多野.
我草擬左條 target curve (Blue) ,
如果我s ...

如果咁我估接駁有啲吉左除非50 crossover

10bucks360

ilccmcf 發表於 2013-5-16 12:52
入左依個..... 睇來有排攪了

我兩隻十仔用XLR要兩隻8033S-II , 不如玩一隻 2.0   ...

幾銀？

elo

Your digital player output connect to this processor input and this processor output connect t your DAC input.  Then connect a microphone to this processer, with a DRC software runs in a PC or Mac, it will measure and calculate FIR curve and then make a compensation data.  The default curve is flat but you can also adjust manually.  Then the software will be transferred to the processor.   Now you can disconnect the PC/Mac and the processor can run alone.  So now the music will go through the processor and the corrected curve will be applied to it.  You better check the procedure stated on their website as  I may not explained 100% correct.

The effect is quite obvious.  In my case, the depth and width of soundstage increase and the too much bass problem was resolved.  The whole feeling is I am listening to music in a bigger room with less acoutics problem.

ilccmcf

10bucks360 發表於 2013-5-16 13:00
幾銀？

因為我係頭水KK訂家, 有特價... 唔洗8K

chung190030

ryanenen 發表於 2013-5-16 12:41
你用ARC plot subwoofer graph係咪?
我一直認為ARC plot graph 表達方式吾同REW.
我用REW plot graph, su ...

thanks, 師兄
有時間會試一試！

ryanenen

claero 發表於 2013-5-16 12:59
如果咁我估接駁有啲吉左除非50 crossover

"接駁有啲吉左"  ???吾明,

"除非50 crossover"-----kelvin 輻graph show xover is 80hz

10bucks360

ilccmcf 發表於 2013-5-16 13:04
因為我係頭水KK訂家, 有特價... 唔洗8K

Set好左上你到玩下可以嗎？

bigpun1975

10bucks360 發表於 2013-5-16 13:18
Set好左上你到玩下可以嗎？

你5d出野先

kelvinchow8

chung190030 發表於 2013-5-16 09:39
我意思係睇你十仔幅圖：由20hz既85db打橫行,去到大約50hz既位就向下降,到咗80hz就只係得返70db, 好似有d ...

因為我呢張圖cal左主/副位 , 後來單一cal主位就無左 .

之後80hz得返70db原因係我前級 / 8033 / 低音同時roll-off80hz所至 , 現在只有前級roll-off80hz就好似最終修正圖一樣回返上黍 .

10bucks360

bigpun1975 發表於 2013-5-16 13:20
你5d出野先

人到中年打空炮冇野出

kelvinchow8

ryanenen 發表於 2013-5-16 11:25
我有問Kelvin show 條 target curve, 先知8033 做到幾多野.
我草擬左條 target curve (Blue) ,
如果我s ...

條target curve係邊度set ? 8033全自動 , 咩都無show . 只會提示你輸入訊號過大或過細 .

而REW就同前級就set好75db cal . 我啱唔啱 ?

kelvinchow8

ilccmcf 發表於 2013-5-16 13:04
因為我係頭水KK訂家, 有特價... 唔洗8K

呢件野set full range架喎 ! 甘重本 !

kelvinchow8

10bucks360 發表於 2013-5-16 13:46
人到中年打空炮冇野出

等你 ! 唔洗急 , 最緊要快 .

ilccmcf

kelvinchow8 發表於 2013-5-16 13:48
呢件野set full range架喎 ! 甘重本 !

平過兩隻8033S II

kelvinchow8

ilccmcf 發表於 2013-5-16 13:54
平過兩隻8033S II

到左手 ? 開箱圖 .

ilccmcf

kelvinchow8 發表於 2013-5-16 13:56
到左手 ? 開箱圖 .

接貨中，晚出野

ryanenen

kelvinchow8 發表於 2013-5-16 13:47
條target curve係邊度set ? 8033全自動 , 咩都無show . 只會提示你輸入訊號過大或過細 .  

而R ...

吾關Antimode 事.
輻圖係REW forum 示範圖,
藍色果條就係target curve,
無依條target curve, 你吾知自己plot graphs 準不準.
8033 apply filters 後, 如果度出尼跟貼target curve 就fit.
下面有格仔鈎選.

"而REW就同前級就set好75db cal . 我啱唔啱 ?"

你REW set75db, 但graph xover係80db??
我估你有REW可能出錯.
再cal.过後再plot grap睇下.

ryanenen

elo 發表於 2013-5-16 13:01
Your digital player output connect to this processor input and this processor output connect t your  ...

師兄, minidsp 都有比multi-channels eq,有無玩过. 吾知点樣選佢地modules?

rookie100fun

ilccmcf 發表於 2013-5-16 12:52
入左依個..... 睇來有排攪了

我兩隻十仔用XLR要兩隻8033S-II , 不如玩一隻 2.0   ...

Yes, using dual-core is more convenient.