|
|
發表於 2016-3-30 22:54:00
|
顯示全部樓層
RX-A2050 Firmware Update Instructions
Back to the list
Go to Product Information
Last Update: 08/20/2015
Firmware Update
Note: This operation will be performed on the front panel of the unit only.
1. Set the unit to standby mode. (Use the Power button on the front panel of the unit.)
2. While holding down the STRAIGHT button, press the POWER button.
3. ADVANCED SETUP and then SP IMP will show up on the front panel. (Make sure you let go of the Straight button.)
4. Press the PROGRAM ARROW button to the left 2 times to get to UPDATE.......USB.
5. Press the STRAIGHT one time to get to UPDATE........NETWORK.
6. Press the INFO button one time on the unit to start the update.
7. When the update is finished, the receiver will say UPDATE SUCCESSFULL PLEASE POWER OFF.
8. Power the unit back on normally and the update is completed.
|
評分
-
2
查看全部評分
-
|